Dispensers Installation

Mount unit on wall or toilet partition with two screws, furnished by manufacturer, at holes in dispenser. For plaster wall construction, provide concealed backing that complies with local building codes, then secure with screws furnished. For other wall surfaces, use screws and expansion plugs provided, or provide 3mm toggle bolts or expansion bolts.
Note- Recommended mounting height off floor is 1.35m to top of dispenser.

Replace Paper

Lockable dispenser - Use key to open lock and swing open from lower hinge.  Remove empty paper box and replace with new paper box.  Close dispenser and lock.

Plastic / Metal dispenser - Fill from bottom through concealed opening.  Push empty pack up and away from you.  Slide out through opening. Insert new pack into opening at bottom of dispenser and slide upward until pack clears lower internal edge.  Pull pack towards you and allow to fall into set position.

Paper Cover Using Instruction

• Pull up then Pull down from the dispensers.

• Tear from the center cutout.

• Spread on the seat cover, flap in the bowl.

• Self disposing when you flush after the use.

Order Now...

Please contact us directly by Emai: suncx@yahoo.com
Or, sunxin@mail.dlptt.ln.cn
Fax: +86 411 82896168 to arrange a sales representative to contact you at your convenience... ...